Brocade Mobility 1220 Access Point Installation Guide - Manual (Page 16)

Integrated antenna model wall mount instructions
2
Brocade Mobility 1220 Access Point Installation Guide 11
53-1002916-01
1. Orient the case on the wall by its width or length.
CAUTION
To ensure proper operation of a Mobility 1220 Access Point, ensure it is
mounted in the correct orientation as shown above.
2. Mark two points (for drill holes) 4.08 inches (103.7 mm) apart on a horizontal
line.
3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the
wall mounting screw and stop when there is 1mm between the screw head and
the wall.
NOTE
When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.).