Brocade Mobility 1220 Access Point Installation Guide - Manual (Page 19)

External antenna model wall mount instructions
2
14 Brocade Mobility 1220 Access Point Installation Guide
53-1002916-01
6. Push the back of the case onto the bottom of the T-bar.
7. Rotate the case 45 degrees counter-clockwise. The clips click as they fasten to
the T-bar.
8. Verify the unit has power by observing the LEDs.
CAUTION
If not using a 802.3af capable device to power the Mobility 1220
Access Point, ensure only the Mobility 1220 Access Point’s designated
power supply (PWRS-14000-148R) is used to supply power to the
access point. Using an incorrectly rated power supply could damage
the unit and void the product warranty. Do not actually connect to the
power source until the cabling portion of the installation is complete.
External antenna model wall mount instructions
A wall mount deployment requires hanging the Brocade Mobility 1220 along its
width or length using the pair of slots on the bottom of the unit. The Mobility 1220
Access Point can be mounted on to any plaster, wood or cement wall surface using
the provided wall anchors.
Wall Mount Hardware
• Two customer provided wide-shoulder Phillips pan head self-tapping screws
(M3.5 x 0.6 x 20 mm)
• Two wall anchors (customer supplied)
• Security cable (optional)
NOTE
The following screws are recommended: (ANSI Standard) #6-18 X 0.875in. Type A or
AB Self-Tapping Screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D
Self-Tapping Screw.