Brocade Multi-Service IronWare Software Defined Networking (SDN) Configuration Guide (Supporting R05.6.00) - Manual (Page 32)

22 Multi-Service IronWare SDN Configuration Guide
53-1003034-02
Configuring OpenFlow
1
Use the show running configuration command:
When OpenFlow is enabled on the device, the show running configuration command displays
output similar to the following:
Brocade(config)# show run
Current configuration:
ver V5.4.0iT183
mirror ethernet 1/19
openflow enable ofv100
Show command
The show OpenFlow command displays the configuration for OpenFlow. It includes the configured
unprotected VLANs as well.
NOTE
LLDP protocol runs on the OpenFlow port, when OpenFlow port is enabled first and LLDP later.
Brocade(config)# show openflow
Administrative Status: Enabled
SSL Status: Enabled
Controller Type: OFV 100
Number of Controllers: 1
Controller 1:
Connection Mode: passive, TCP,
Listening Address: 0.0.0.0
Connection Port: 6633
Connection Status: TCP_LISTENING
Match Capability:
L2 : Port, Source MAC, Destination MAC, Ether type, Vlan, Vlan PCP
L3 : Port, Vlan, Vlan PCP, Ethertype(IP,ARP,LLDP), Source IP, Destination IP, IP
Protocol, IP TOS, IP Src Port, IP Dst Port
L23: All
Normal Openflow Enabled Ports:
Openflow Hybrid Interfaces:
e1/1
Protected VLANs : None
Unprotected VLANs : 2, 3, 4, 5, 6, 7, 8, 9, 10, 11
......................................................
......................................................
3994, 3995, 3996, 3997, 3998, 3999, 4000, 4001, 4011,
e2/1
Protected VLANs : None
Unprotected VLANs : 4010,
Default action: drop
Maximum number of flows allowed: 65536
Active flow: 0
Maximum number of Protected Vlans allowed: 2048
Maximum number of Unprotected Vlans allowed: 4096
Total number of Unprotected Vlans: 4002