Brocade Multi-Service IronWare Software Defined Networking (SDN) Configuration Guide (Supporting R05.6.00) - Manual (Page 25)

Multi-Service IronWare SDN Configuration Guide 15
53-1003034-02
Hybrid switch and OpenFlow hybrid port mode
1
Brocade(config-mpls-vpls-v8-vlan-100)#tag e 2/8
Brocade(config-mpls)#int e 2/8
Brocade(config-if-e10000-2/8)#openflow protected-vlans 100
Brocade(config-if-e10000-2/8)#openflow enable layer2 hybrid-mode
Since this protected VLAN has become part of VPLS VLAN on this port, VPLS switching on this
protected VLAN will be supported.
Deleting VPLS instances from protected VLAN
To remove VPLS instance for protected VLAN from OpenFlow hybrid mode port, use this sequence
of commands.
Brocade(config)#
Brocade(config)#router mpls
Brocade(config-mpls)#
Brocade(config-mpls)#vpls v1 100
Brocade(config-mpls)#vpls-peer 17.17.17.17
Brocade(config-mpls-vpls-v1)#vlan 100
Brocade(config-mpls-vpls-v8-vlan-100)#tag e 2/8
Brocade(config-mpls)#int e 2/8
Brocade(config-if-e10000-2/8)#openflow protected-vlans 100
Brocade(config-if-e10000-2/8)#openflow enable layer2 hybrid-mode
Brocade(config)#
Brocade(config)#
Brocade(config)#router mpls
Brocade(config)#vpls v1 100
Brocade(config)#vlan 100
Brocade(config)#no tag e 2/8
Now this port is not a part of VPLS instance. The protected vlan will become unconfigured protected
vlan. It will drop.
NOTE
When removing protected VLAN configuration, do not exceed the system-max unprotected VLAN
number. The command will be rejected and you will get an error message.
After removing the protected VLAN configuration, this VPLS VLAN will become configured as an
unprotected VLAN. Now, It will do VPLS switching in absence of matching flow.
Deleting VPLS instances from unprotected VLAN
To remove OpenFlow hybrid mode from a port with unconfigured protected VLAN and a VPLS
instance, execute the following commands.
Brocade(config)#
Brocade(config)#router mpls
Brocade(config-mpls)#
Brocade(config-mpls)#vpls v1 100
Brocade(config-mpls)#vpls-peer 17.17.17.17
Brocade(config-mpls-vpls-v1)#vlan 100
Brocade(config-mpls-vpls-v8-vlan-100)#tag e 2/8
Brocade(config-mpls)#int e 2/8
Brocade(config-if-e10000-2/8)#openflow protected-vlans 100
Brocade(config-if-e10000-2/8)#openflow enable layer2 hybrid-mode
Brocade(config)#
Brocade(config)#router mpls
Brocade(config)#vpls v1 100
Brocade(config)#vlan 100