Nexo LS18 - Manual (Page 49)

GEO S12 HARDWARE SETUP PROCEDURE Page 49/103
8.4.4 Single GEO S12 flown horizontally
Required items
 1 x “U” Bracket for single horizontal GEO S12 (GPT-SSBRK)
 1 x Lifting Ring (VNT-XHBRK)
 Or 1 x Truss hook (VNT-TCBRK)
IMPORTANT
Ensure that suspension point is strong enough to hold GEO S12 weight.
Procedure
 Slide GPT-SSBRK side plates into GEO S12 connecting plate oblong holes;
 Lock safety pins into GEO S12 connecting plate;
IMPORTANT
Ensure that safety pins are properly locked into GEO S12 connecting panels.
 Position “U” bracket over these side plates; align center holes;
 Insert adjustment handles, adjust vertical angle and tight the handles to prevent GEO
S12 from rotating around “U” bracket;
Cable suspension:
 Connect lifting ring VNT-XHBRK to “U” bracket by inserting 8x45 quick release pin
dedicated holes;
 Ensure lifting ring is properly locked to “U” bracket;
 Connect assembly to suspension point with sling and shackle (not provided).
Truss suspension
 Connect truss hook VNT-TCBRK to “U” bracket by inserting 8x45 quick release pin in
dedicated holes;
 Ensure truss hook is properly locked to “U” bracket;
 Lift and position assembly, lock hook on truss suspension point and secure with hook
cable.