Nexo LS18 - Manual (Page 46)

Page 46/103 GEO S12 HARDWARE SETUP PROCEDURE
8.4.2 Single GEO S12 on speaker stand or on LS18 horizontally
Required items
 1 x “U” Bracket for single horizontal GEO S12 (GPT-SSBRK);
 1 x Speaker stand diameter 35mm (K&M 213 or equivalent);
 Or NEXO PS pole stand (VXT-PLSTD) for mounting on top of LS18
IMPORTANT (SPEAKER STAND)
- Speaker stand must be rated for assembly weight (40kg rated load min);
- Speaker stand must always be installed on a horizontal surface;
- Stand height and footprint must be defined to prevent assembly from collapsing;
- Ensure that public is not allowed within a safety area which radius is equal or higher
than assembly height.
IMPORTANT (LS18 POLE STAND)
- NEXO PLSTD pole stand only should be used for mounting on top of NEXO LS18
- LS18 must always be installed on a horizontal surface;
- Ensure that public is not allowed within a safety area which radius is equal or higher
than assembly height.
Procedure
 Slide GPT-SSBRK side plates into GEO S12 connecting plate oblong holes;
 Lock safety pins into GEO S12 connecting plate;
IMPORTANT
Ensure that safety pins are properly locked into GEO S12 connecting panels.
 Position “U” bracket over these side plates; align centre holes;
 Insert adjustment handles, adjust vertical angle and tight the handles to prevent GEO
S12 from rotating around “U” bracket;
 Lift assembly on speaker stand or on LS18 with PLSTD pole stand.