Required items, Procedure – Nexo LS18 User Manual
Page 35
GEO
S12
HARDWARE SETUP PROCEDURE
Page 35/103
8.3.3 Single GEO S12 cable mounted on a wall or a ceiling (vertical or horizontal)
Required items
1 or 2 x VNI-LBRK (allows cable suspension, holes for cable suspension are 10mm
diameter);
2 or 4 slings and corresponding shackles (not provided)
IMPORTANT
Ensure that the ceiling is strong enough to hold GEO S12 weight and that the cable
suspension system required to install the cabinet under the ceiling is properly
dimensioned.
Procedure
Vertical
Remove the four TORX screws holding
connector plate on upper side of GEO S12;
Remove the connector plate from Geo S12;
Apply Loctite 243 or equivalent to the 4
shoulder screws from VNI-LBRK;
Position external plate from VNI-LBRK kit
and secure it using the 2 of the 4 shoulder
screws;
Position “L” bracket from VNI-LBRK kit, and
secure it to the cabinet using the 2 remaining
shoulder screws;
Slings and shackles (not provided) are
required to secure the cluster under the
ceiling;
Horizontal
Remove the four TORX screws holding
connector plates on both side of GEO S12;
Remove the connector plates from Geo S12;
Apply Loctite 243 or equivalent to the 4
shoulder screws from VNI-LBRK;
Position external plates from VNI-LBRK kits
and secure them using the shoulder screws;
Position “L” brackets from VNI-LBRK kits,
and secure them to the cabinet using the 4
remaining shoulder screws;
Slings and shackles (not provided) are
required to secure the cluster under the
ceiling;