Controls and connections, Quick route: digital, Quick route: monitors – PreSonus FireStudio User Manual
Page 37: Quick route: auto, P2: phones 2, P3: phones 3
CONTROLS AND CONNECTIONS
34 | PreSonus 2008
Quick Route section
During a recording session, time is of the essence. The Quick Route section allows you to assign the current
monitor mix to the any physical output without bringing up the Outputs/Router matrix. As explained in
section 3.1.4, there are two modes for the Quick Route option: Digital and Monitors. When Digital is
enabled, all 18 of the outputs available in the FireStudio Device window are visible.
See below:
Quick Route: Digital
Selecting any or all of the output buttons will route the current
mix to the enabled output. The buttons will turn blue when
enabled.
When “Monitors” is selected on the Hardware Settings tab, the Quick Route section allows you to assign the
current mix to any analog output and to automatically route the current mix to either the Main outs or to one
of the headphone outputs. This enables you to quickly preview mixes as you scroll through the nine monitor
mixes. Please note: the digital outputs are still accessible and the mixes can still be routed to them on the
Outputs/Router Matrix.
Quick Route: Monitors
Selecting any of the output buttons will route the current mix to
the enabled output.
MO: Main Output
P1: Phones 1
P2: Phones 2
P3: Phones 3
Please note: The MSR must be connected for Phones 2 and 3 to
be accessible.
Quick Route: Auto
The Auto feature will automatically route whatever mix is
currently selected to a chosen monitor output. This allows you to
switch between mixes without having to select a new monitor
routing each time.