MAHLE RTI RHS980C - Manual (Page 37)

36
S E L E C T D E M O M O D E
A U T O M A T I C
M A N U A L
C O N T I N U E ?
S I G N A L W I L L C H A N G E
A U T O M A T I C A L L Y A F T E R
3 0 S E C O N D S
C O N T I N U E ?
S E N D I N G R U N N I N G
L E D G R E E N, B U Z Z O F F
V I B O F F, T I M E L E F T # #
S T O P T O E N D
S E N D I N G F A U L T
L E D R E D, B U Z Z O F F
V I B O N, T I M E L E F T # #
S T O P T O E N D
S E N D I N G C O M P L E T E
L E D G R N/ Y E L, B U Z Z O N
V I B O N, T I M E L E F T # #
S T O P T O E N D
S E N D I N G C L E A R S I G N A L
L E D O F F, B U Z Z O F F
V I B O F F, T I M E L E F T # #
S
T O P T O E N D
S E L E C T D E M O M O D E
A U T O M A T I C
M A N U A L
C O N T I N U E ?
P R E S S # 1 = R U N , # 2 =
F A U L T , # 3 = C O M P L E T E ,
# 0 = C L E A R
S T O P T O E N D
Select either the AUTOMATIC mode or MANUAL
mode, if AUTOMATIC mode is selected follow the
subsequent 5 screens. If MANUAL was selected see
below. Use the ▲ or ▼ key to change the selection.
Press START key.
The signal will be sent for 30 seconds before switching
to the next signal.
RUNNING signal being sent.
FAULT signal being sent.
COMPLETE signal being sent.
Press the STOP key to end TechALERT automatic
demo mode.
If MANUAL mode is selected follow the subsequent
screens. Use the ▲ or ▼ key to change the selection.
Press START key.
When in TechALERT manual demo mode, push the
corresponding key on the keypad to witness the
desired signal.
Press the STOP key to end the TechALERT manual
demo mode.