MAHLE RTI RHS980C - Manual (Page 26)

25
P R I N T E R I N S T A L L E D ?
► Y E S
N O ▲
▼
Default is YES.
P R I N T T O F L A S H D R I V E
► Y E S
N O ▲
▼
Default is YES.
L O W V O L T A G E D E T E C T
E N A B L E D ?
► Y E S ▲
N O ▼
Default is YES.
M I C R O N V A C U U M
S E N S O R E N A B L E D ?
► Y E S ▲
N O ▼
Default is YES.
P A S S W O R D P R O T E C T I O N
E N A B L E D ?
► Y E S ▲
N O ▼
Default is YES.
E N T E R P A S S W O R D
# # # #
S T A R T T O C O N T I N U E ▲
S T O P T O E N D ▼
S T A R T U P P A S S W O R D
E N A B L E D ?
► Y E S ▲
N O ▼
Default is YES.
V I N E N T R Y E N A B L E D ?
► Y E S ▲
N O ▼
Default is YES.
O P E R A T O R I D E N T R Y
Y E S ▲
► N O ▼
Default is NO.
A C T E S T M O D E
E N A B L E D ?
► Y E S ▲
N O ▼
Default is YES.
Use to enable or disable the on board printer on the
RHS980C . Press the ▲ or ▼ key to scroll to YES or
NO. Press START key.
Use to enable or disable printing service results or
setup parameters as files on the attached flash drive.
Press the ▲ or ▼ key to scroll to YES or NO. Press
START key.
Use to enable or disable the Low Voltage Detect on
the RHS980C. Press the ▲ or ▼ key to scroll to YES
or NO. Press START key.
Use to enable or disable the Micron Vacuum Sensor
on the RHS980C. Press the ▲ or ▼ key to scroll to
YES or NO. Press START key.
This feature can be enabled on the base RHS980C-
NAV. IMPORTANT The manager password will also
be required to make any changes in the Selectable
Options and the Default Values sections if enabled.
See Maintenance Options in regards to default
password and changing passwords. Press START
key. If NO is selected the following screen will be
shown.
Default Service Managers password is 5237, enter this
password to continue. Proceed to Maintenance
Section to see how to change default password to one
of the 20 optional passwords. Press START key.
An operator password will be required to proceed with
any operation after powering the unit if this feature has
been enabled.
This feature allows the vehicles VIN to be entered that
is being serviced. Press START key.
Use to enable or disable the Operator ID Entry feature
on the RHS980C. Press the ▲ or ▼ key to scroll to
YES or NO. Press START key.
Use to enable or disable the AC Test Mode feature on
the RHS980C. Press the ▲ or ▼ key to scroll to YES
or NO. Press START key.