MAHLE RTI RHS980C - Manual (Page 15)

14
O I L D R A I N I N P R O C E S S
P L E A S E W A I T
S T O P T O E N D
R E C Y C L E I N P R O C E S S
A M T R E C # # . # L B
T I M E L E F T # # M I N
S T O P T O E N D
V A C U U M I N P R O C E S S
T I M E L E F T # # M I N
L E V E L # # # # # M I C R O N
S T O P T O E N D
C H E C K I N G V A C U U M L E A K
T I M E L E F T # # S E C
L E V E L # # # # # M I C R O N
S T O P T O E N D
V A C U U M I N P R O C E S S
T I M E L E F T # # M I N
L E V E L # # # # # M I C R O N
S T O P T O E N D
P U R G E I N P R O C E S S
P L E A S E W A I T
S T O P T O E N D
C L E A R I N G I N P R O C E S S
P L E A S E W A I T
S T O P T O E N D
C H A R G E I N P R O C E S S
A M T C H G = # # . # L B
D O N O T D I S T U R B U N I T !
S T O P T O E N D
A U T O M A T I C C O M P L E T E
A M T R E C # # . # L B
A M T C H G # # . # L B
C O N T I N U E ?
S T A R T T O E V A C H O S E S
S T O P T O T E S T M O D E
When the vehicle system reaches 10 psi, the machine
will drain any recovered oil.
The RHS980C will continue to recycle refrigerant and
complete after the time shown is expired.
The RHS980C will draw a deep vacuum on the A/C
system for the time entered in the default vacuum run
time in the set up menus. The time left and the
vacuum level in micron will be displayed if Enhanced
vacuum is selected.
The vacuum leak test will begin. The time left and the
micron level will be displayed if Enhanced vacuum is
selected. If the vacuum level rises above leak level
set in set up default menu, an error screen will be
displayed.
A second deep vacuum process will run for the length
of time displayed.
The RHS980C will purge air from the recovered
refrigerant if necessary. This process will be displayed.
A clearing procedure will run to remove refrigerant
from internal components.
The RHS980C will charge the amount of refrigerant
set previously into the A/C system. TO AVOID AN
INACCURATE CHARGE, DO NOT BUMP OR MOVE
THE RHS980C DURING THIS PROCESS.
The automatic cycle is complete when the desired
amount of refrigerant has been charged. The amount
of refrigerant recycled and the amount of refrigerant
charged will be displayed. Press START key.
Press START key to proceed to the hose evacuation
procedure as outlined below. Press STOP key to
perform AC system test mode. See A/C SYSTEM
TEST MODE for a description of this feature.