Yokogawa µR20000 - Manual (Page 81)

SM 04P01B01-01E 7-16
6. Remove the FPCs. Release the latches on the Pen Driver PCB, then separate
the Pen Servo Assembly and Pen Driver PCB.
FPC
FPC
FPC
FPC Latch
Latch
Note
The connector connected to the FPC from the Pen Servo Assembly on the Pen Driver PCB
does not have a locking mechanism. Inserting and removing it repeatedly can result in worn
or defective contacts.
6. Remove the Pin from the Pen Servo Assembly, then remove the Pen Arm Assembly.
Pin
Pen Arm Assembly
Pen number
Note
The pen number is indicated on the Pen Arm Assembly. When assembling, make sure to
use correct Pen Arm Assembly. Otherwise, the Pen Arm Assemblies will interfere with each
other.
7.3 Disassembly