Yokogawa RAMC User Manual
Yokogawa Sensors
Table of contents
Document Outline
- 1. Introduction
- 1.1 ATEX Documentation
- 2. Precautions
- 3. Installation
- 4. Start of operation
- 5. Limit switches (Option /K[])
- 6. Electronic Transmitter (-E)
- 6.1 Operation principle
- 6.2 Parameter setting
- 6.2.1 Selection of indication function (F11)
- 6.2.2 Setting the unit (F12 / F13)
- 6.2.3 Totalizer reset (F14)
- 6.2.4 Selection of temperature unit (F15)
- 6.2.5 Setting of damping (F2-)
- 6.2.6 Selection / Adjustment 4-20 mA / 0-20 mA (F3-)
- 6.2.7 Pulse output (F34) (Option /CP)
- 6.2.8 Error messages (F4-)
- 6.2.9 Manual adjustment (F5-)
- 6.2.10 Revision indication (F61/F62)
- 6.2.11 Current output test (F63)
- 6.2.12 Switching between standard / Indicator on extension (F64)
- 6.2.13 Master Reset (F65)
- 6.2.14 Float blocking indication (F7-)
- 7. HART® - Communication
- 8. Service
- 9. Technical Data
- 10. Explosion-protected Type Instruments
- 10.1 General
- 10.2 Intrinsically safe ATEX certified components (/KS1)
- 10.3 Nonincendive components for Category 3 (ATEX) (/KN1)
- 10.4 Intrinsically safe SAA (Australia) certified RAMC (/SS1)
- 10.4 Intrinsically safe ATEX certified components for category 3G (/KS3)
- 10.5 Intrinsically safe IECEx- certified components (/ES1)
- 10.6 Intrinsically safe IECEx- components for category 3G (/ES3)
- 10.7 Intrinsically safe FM / CSA (USA + Canada) components (/FS1, /CS1)
- 10.8 Intrinsically safe NEPSI (China) certified RAMC (/NS1)
- 10.9 Flame proof and dust proof ATEX certified RAMC (/KF1)
- 10.10 Flame proof and dust proof IECEx certified RAMC (/EF1)
- 10.11 Intrinsically safe ATEX certified components in dust proof RAMC-housing (/KS2)
- 10.12 Intrinsically safe IECEx certified components in dust proof RAMC- housing (/ES2)
- 10.13 Flame proof and dust proof NEPSI (China) certified RAMC (/NF1)
- 11. Instructions for PED
- APPENDIX 1. Software change History
- APPENDIX 2. Safety Instrumented Systems Installation