Yokogawa EJX118A - Manual (Page 58)

<8. General Specifications>
8-16
IM 01C25H01-01E
*6: The unit of MWP (Max. working pressure) on the name plate of a housing is the same unit as specified by option code D1, D3, and
D4.
*7: Applicable for output signal code D, E and J. The hardware error indicates faulty amplifier or capsule.
*8: Specify the process operating temperature for zero correction. Example: Zero correction by process temperature 90°C.
*9: Applicable for wetted parts material code SW, SE, SY, and HW.
*10: Also see ‘Ordering Information.’
*11: Applicable for flushing connection ring code 0. Not applicable for Fill fluid code 1, 2, or 4.
*12: Check terminals cannot be used when this option is specified. Not applicable for output signal code F and amplifier housing code 2.
*13: Applicable only for output signal code -E and -J.
*14: The change of pressure fluctuation is monitored and then detects the impulse line blockage. See TI 01C25A31-01E for detailed
technical information required for using this function.
*15: Applicable for flushing connection ring code 1, 2, 3, 4, A, B, C, and D.
*16: Applicable for flush type (process connection style code W.)
*17: Applicable for extended type and Combination type (process connection style code E and Y.)
*18: Pure nitrogen gas is used for oil-prohibited use (option code K1and K5.)
*19: The unit on the certificate is always MPa regardless of selection of option code D1, D3, or D4. A flushing connection ring will not be
applied when conducting the pressure test or leak test.