Watlow Series L Temperature Limit - Manual (Page 7)

Wa t l ow S e r i e s L • 5 • C h a p te r 2 : I n s t a l l a t i o n
is also seated properly and not twisted. The hard-
ware installation is complete. Proceed to the wir-
ing section.
2. Insert the controller into the panel cutout.
3. While pressing the bezel firmly against the panel,
slide the mounting bracket over the back of the
controller. Be sure the levers on the mounting
bracket line up with the teeth on the case.
4. Press the bracket up to the back of the panel. The
controller should fit tightly in the panel cutout.
Removing the Panel Mount Square
1/8 DIN Controller
1. Remove power from the system.
2. Remove all the wiring connections from the back
of the controller.
3. Slide a thin, wide tool (putty knife) under all three
mounting tabs, top then bottom, while pushing for-
ward on the back of the case. Be ready to support
the controller as it slides out of the panel cutout.
ç
Caution: FM approval requires limit switches to be
suitably enclosed to restrict casual user adjustment.