Danger, Warning – Proface PS4800 - 19 Panel PC" User Manual
Page 10
PS-4000B Series User Manual
10
Product Related Information
PS-B units are certified for use in Class I, Division 2 hazardous locations as defined
in ANSI/ISA 12.12.01 or CSA C22.2 N
°213. Observe the following:
NOTE: PS-B is a highly configurable device and is not based on a real-time
operating system. Changes to the software and settings of the following must be
considered new implementations as discussed in the previous warning messages.
Examples of such changes include:
z
System BIOS
z
System Monitor
z
Operating system
z
Installed hardware
z
Installed software
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
z
Remove all power from the device before removing any covers or elements of
the system, and prior to installing or removing any accessories, hardware, or
cables.
z
Unplug the power cable from both the PS-B unit and the power supply.
z
Always use a properly rated voltage sensing device to confirm power is off.
z
Replace and secure all covers or elements of the system before applying power
to the unit.
z
Use only 24 Vdc when operating the PS-B unit.
Failure to follow these instructions will result in death or serious injury.
WARNING
LOSS OF CONTROL
z
The designer of any control scheme must consider the potential failure modes
of control paths and, for certain critical control functions, provide a means to
achieve a safe state during and after a path failure. Examples of critical control
functions are emergency stop and overtravel stop.
z
Separate or redundant control paths must be provided for critical control
functions.
z
System control paths may include communication links. Consideration must be
given to the implications of unanticipated transmission delays or failures of the
link.
*1
z
Each implementation of a PS-B unit must be individually and thoroughly tested
for proper operation before being placed into service.
*1
For additional information, refer to NEMA ICS 1.1 (latest edition), "Safety
Guidelines for the Application, Installation, and Maintenance of Solid State
Control" and to NEMA ICS 7.1 (latest edition),"Safety Standards for Con-
struction and Guide for Selection, Installation and Operation of Adjustable-
Speed Drive Systems" or other applicable standards in your location.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.