Ramsey Winch H-800 W/AIR SHIFTER (TALBERT) - Manual (Page 13)

(11)
Check drum bushings (items #39 & #40) for signs
of wear. Replace if necessary by pressing old bush-
ings from drum (item #17). Press bushing (item
#39) into bore in drum until its flange is seated
against bottom of counterbore. Press bushing (item
#40) into opposite bore on drum until end of bush-
ing extends .50" from end of drum.
(12)
Check end bearing bushing (item #36) for signs of wear. If necessary,
remove old bushing and press new bushing into place.
(13)
Check cover bushing (item #10) and quad ring (item #84) for signs of
wear. Replace if necessary by pressing old bushing from gear housing
cover (item #16). Press new bushing into place and insert new quad ring
into groove inside of bushing.
RE-ASSEMBLY
(14)
Slide spacer (item #98) over long end of shaft and place
against gear hub. Apply grease to end of shaft, opposite
gear. Apply grease to bushing in gear housing (item #21).
Place greased end of shaft through bushing in gear hous-
ing. Place gasket (item #78) onto gear housing cover (item
#16). Apply grease to gear end of shaft and cover bush-
ing. Place cover onto shaft and secure to housing with
eight (item #45) capscrews. Tighten capscrews to 39 ft-lb.
(52 Nm.) torque each.
13