Ramsey Winch H-800 W/AIR SHIFTER (TALBERT) User Manual

Page 10

INSTRUCTIONS FOR OVERHAUL OF RAMSEY MODEL H-800 DOW-LOK®

Dis-assembly

Refer to parts list and parts drawing pages for actual item num-
bers and corresponding parts numbers.

(1)

Drain oil from gear housing by removing pipe plug (item #87)
from gear housing.

Shift clutch into the engaged "IN" position.

Remove frame angles (items # 7 & 8) from winch assembly.

(2)

If the air cylinder and shifter needs to be removed, remove the (4) capscrews (item #58) that hold the shifter cover
(item #41) onto the shifter bracket (item #5). Remove cotter pin (item #73) and clevis pin (item #74) that hold cle-
vis (item #29) to shifter shaft and yoke.

Remove the screws (item #50) that attach the yoke to the clutch housing. The screws (item #54) and nuts (item
#60) on the yoke can be removed after removing the clutch housing from the drum. To remove shifter shaft (item
#30) from yoke (item #34), remove roll pin (item
#90).

Unscrew setscrew (item #57) from air cylinder
(item #75) and remove jam nut (item #61) if
needed.

To remove the air cylinder from the shifter bracket
(item #5), remove 4 screws (item #59) and
lockwashers (item #65). To remove the bracket
from the clutch housing (item #21), remove 4
capscrews (item #44).

NOTE: It will be necessary to pull the yoke and
shifter shaft upward inside the clutch housing as
far as it will go in order to clear the locking ring.

71 53