Ramsey Winch RPH-30000T-117 - Manual (Page 11)

7. Remove output coupling (item #8) and coupling shaft (item #7) from end bearing (item #10).
Examine bearings (item #17), pressed in output coupling (item #8), for signs of wear. Replace
bearings, if necessary, by pressing old bearings from coupling and press new bearings (item #17)
into each end of output coupling (item #8). Place coupling shaft (item #7) into bearings (item
#17).
8. Remove (12) capscrews (item #20) to pull gear housing cover from ring gear. Remove input
thrust washer, sun gear and carrier assemblies from inside of ring gear. Remove ring gear from
end bearing (item #10). Examine shifter shaft (item #14) for signs of wear, replace if necessary.
Examine bushing (item #19) for signs of wear. Replace bushing, if necessary, by pressing old
bushing from housing and pressing new bushing into place.
9