Ramsey Winch RPH-35000 - Manual (Page 9)

5. Pull drum assembly (item #1) upward from end bearing (item #9). Remove quad-rings
(item #39 & #40) from grooves in drum bushings. Remove input shaft (item #11),
clutch spring (item #44) and washer (item #28) from end bearing (item #9). Examine
key (item #10) and input shaft for signs of wear, replace if damaged.
Examine drum assembly (item #1) for signs of wear. If splines inside of drum driver
(332162) are damaged, drum driver must be replaced. Remove drum driver by unscrew-
ing (8) capscrews (414964). Place well oiled o-ring (462053) into drum driver groove
and attach driver to drum (332196) using (8) capscrews (414964). Torque capscrews
to 120 ft. lbs. each, in criss-cross pattern.
Press old bushings from drum and drum driver. Remove o-rings (462054 & 462052)
from grooves in drum and drum driver bushing (412088). Place well oiled o-rings
(462054 & 462052) into grooves in drum and outer diameter of drum driver bushing
(412088). Press new bushing (412087) into end of drum opposite drum driver and
press bushing (412088) into drum driver until flange of bushings are flush against drum
and driver.
7