Ramsey Winch RPH-35000 - Manual (Page 7)

INSTRUCTIONS FOR OVERHAUL
1. Drain oil from gear hous-
ing (item #9) by remov-
ing plug (item #42) from
end bearing. Remove
reducer and relief fitting
(items #41 & #36).
If new air cylinder is
required, remove air cylin-
der (item #32) from
adapter (item #4) by
removing (4) capscrews
(item #23). Remove
washer (item #25), nut
and setscrew (items #26 & #21) and insert (item #29) from end of air cylinder rod.
Apply Loc-tite to threads of nut (item #26) and thread onto setscrew (item #21) to 3/8
inch from drive end, as shown at right. Apply Loc-tite to threads of setscrew and thread
insert (item #29) over end of setscrew and against nut. Use setscrew and nut to thread
insert (item #29) into end of air cylinder rod. Tighten nut against cylinder rod, keeping
3/8 inch distance from drive end of setscrew to nut. If breather vent (item #37) is dam-
aged, remove and replace. Remove air cylinder adapter (item #4) and gasket (item #34)
from gear housing cover by unscrewing (4) capscrews (item #17).
2. Disconnect tube (item #45) from
elbow (item #30) on valve (item
#46) and fitting on bottom of brake
assembly (item #31). Remove motor
(item #38) and gasket (item #35) by
removing (2) capscrews (item #20).
Remove valve (item #46), if needed,
from motor by loosening (3) cap-
screws.
5