Ramsey Winch RPH-35000 - Manual (Page 13)

12. Align keyway of coupling (item #6) with key on end of input shaft. Slide coupling over
end of shaft. Place gasket (item #33e) into position on motor mounting surface of end
bearing (item #9). Use (2) screws (item #19) to attach the adapter plate (item #33c) to
motor end bearing. Torque capscrews to 85 ft-lbs. each. Place second gasket (item
#33e) on adapter plate. Insert brake shaft with key (item #33c) into coupling. Alternately
tighten one, then the other of the capscrews (item #47) in a back and forth manner, thus
compressing spring (item #44) and pulling the brake down against the adapter plate.
Torque capscrews to 97 ft-lbs each.
NOTE: Care must be taken to assure cover and brake module are seated properly prior to
installing 1/2-13UNC assembly bolts. Damage will occur to rotor stack or shaft snap ring
if not properly seated.
13. Attach motor (item #38) with gasket (item #35) to brake (item #33). Use (4) cap-
screws (item #20) and torque to 74 ft. lbs. each. Securely connect tube (item #45) to
fitting (item #31) on underside of brake and fitting (item #30) on valve (item #46).
19
47
47
33c
31
33a
33e
33d
33e
19
9
7
11