Ramsey Winch RPH-35000 - Manual (Page 12)

10. Apply RTV sealing compound to ring gear mounting surface of end bearing (item #9).
Place ring gear onto end bearing, aligning holes in ring gear with holes and gear housing
end bearing. Use (2) capscrews to temporarily secure ring gear to end bearing.
Place (2) gear carrier assemblies into
ring gear meshing carrier gears with
ring gear. Remove (2) temporary
capscrews, making sure that ring
gear and carrier assemblies are
securely against end bearing (item
#9). Apply RTV sealing compound
to cover mounting surface of ring
gear (item #3) and attach cover to
ring gear. Use (12) capscrews (item
#15) to secure gear box to gear
housing end bearing. Torque cap-
screws to 39 ft. lbs. each, in criss-
cross pattern.
11. Slide input sun gear over shifter shaft (item #12) and mesh with teeth of input carrier.
Apply grease to input thrust washer and place into slots of air cylinder adapter (item #4).
Place gasket (item #34) into position on gear box cover with sealer and attach adapter to
cover using (4) capscrews (item #17). Apply Loctite PST thread sealer to threads of
capscrews. Torque capscrews to 13 ft. lbs. each, in criss-cross pattern.
Pull rod from air cylinder as far as possible. Slide washer (item #25) over setscrew (item
#21) and against nut attached to air cylinder rod. Place setscrew into hole of shifter
shaft (item #12). Attach new air cylinder (item #32) and gasket (item #34) with sealer,
to adapter using (4) capscrews (item #23). Apply Loctite PST thread sealer to threads of
capscrews. Torque capscrews to 5 ft. lbs. each, in criss-cross pattern.
10