Ramsey Winch RPH-35000 - Manual (Page 10)

6. Remove output coupling (item #7) and coupling shaft (item #5) from end bearing (item
#9). Examine bearings (item #13), pressed in output coupling, for signs of wear.
Replace bearings, if necessary, by pressing old bearings from coupling and press new
bearings into each end of output coupling. Place coupling shaft into bearings.
7. Remove (12) capscrews (item #15) to pull gear housing cover from ring gear. Remove
input thrust washer, sun gear and carrier assemblies from inside of ring gear. Remove
ring gear from end bearing (item #9). Examine shifter shaft (item #12) for signs of
wear, replace if necessary. Examine bushing (item #14) for signs of wear. Replace
bushing, if necessary, by pressing old bushing from housing and pressing new bushing
into place.
8