Ramsey Winch DC-200 SERIES RAM-LOK - Manual (Page 3)

1
PLEASE READ THIS MANUAL CAREFULLY.
This manual contains useful ideas in obtaining the most effi cient operation from your Ramsey Winch,
and safety procedures one needs to know before operating a Ramsey Winch.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifi cations. Great care and skill go into every
winch we make. If the need should arise, warranty procedure is outlined on the back of your self-ad-
dressed postage paid warranty card. Please read and fi ll out the enclosed warranty card and send it
to Ramsey Winch Company. If you have any problems with your winch, please follow instructions for
prompt service on all warranty claims. Refer to back page for limited warranty.
*SPECIFICATIONS: Conforms to SAE J706
Rated Line Pull 1st Layer (l bs.)................................................................................................ 8,000
(kgs.)................................................................................................ 3,630
Total Gear Reduction: DC-200..................................................................................................... 470
DC-246.................................................................................................... 360
Weight: DC-200/DC-246 (long drum) .................................................................. 116 lb. (52.6 Kgs.)
DCY-200/DCY-246 (short drum).............................................................. 105 lb. (47.6 Kgs.)
MAXIMUM GEAR BOX OIL TEMPERATURE SHOULD NOT EXCEED................................................ 250 0 F
Layer of Cable 1 2 3 4
Rated Line Pull Lbs. 8,000 6,700 5,700 5,000
per layer Kgs. 3,620 3,030 2,580 2,260
Long Drum Cable Ft. 25 60 95 140
capacity per layer M. 7 18 28 42
Short
"
Y
"
Drum
cable capacity Ft. 15 30 55 75
per layer M. 4 9 16 22
NO LOAD 2000#LOAD 4000# LOAD 8000# LOAD
Line Speed FPM FPM FPM FPM
VOLTS (MPM) AMPS (MPM) AMPS (MPM) AMPS (MPM) AMPS
DC-200/DCY-200 12 14 65 7 110 5 180 3.5 280
DC-24-200/DCY-24-200 24 (4.3) . 30 (2.1) . 50 (1.5) . 90 (1.1) . 140
DC-246/DCY-246 12 16.5 70 8.5 140 5.5 200 3.5 330
DC-24-246/DCY-24/246 24 (5) · 35 (2.5) . 70 (1.7) . 100 (1.1) . 160
RAMSEY ELECTRICAL WINCH MODEL DC-200 SERIES
6
180
5
4
3
2
1
0
270 360
MINUTES
AMPS
90 120 160 190
1
2
3
4
5
0
MINUTES
AMPS
12V 24 V
Winch duty cycles are shown below:
*These specifi cations are based on recommended 3/8 inch dia. extra improved
plow steel wire rope or equivalent.
Winch only conforms to SAE J706. For SAE qualifi cation of mounting angles,
if applicable, consult Ramsey Engineering.
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.