Ramsey Winch DC-200 SERIES RAM-LOK - Manual (Page 19)

17
17. Press bearing (item #25) onto worm (item #23)
NOTE: Be sure thick shoulder of bearings outer
race (side with manufacturer's name and
number ) is out, away from worm threads. Press
bearing and worm into gear housing. Slip gasket
(item #43) onto bearing cap (item #6). Use four
capscrews (item #26) to secure cap to gear
hous ing. Torque capscrews to 7 ft-lbs. (9.4 Nm)
each.
Attach solenoid assembly (item #2) to gear hous-
ing. Use two (item #34) capscrews and three
(item #30) capscrews with three fl atwashers
(item #40). Tighten capscrews to 7 ft-lbs. (9.4
Nm) each. Insert plug (item #56) into tapped hole
of cover. Permatex may be applied to threads to
help prevent oil leakage. TIGHTEN plug
securely.
18. Press bearing (item #25) onto worm and
into worm gear housing. NOTE: Be sure
thick shoulder of bearings outer race
Iside with manufacturer's name and num-
ber) is out, away from worm threads.
Place gasket (item #43) onto spur gear
housing (item #16). Secure spur gear
housing to worm gear housing using four
capscrews (item #33). Torque capscrews
to 7 ft-lbs. (9.4 Nm) each.
Mount motor (item #51) to spur gear
housing (item #16) using three lockwash-
ers and nuts (items #39 & #41). Attach
solenoid cables to motor terminals.
Tighten all nuts securely.