Ramsey Winch DC-200 SERIES RAM-LOK - Manual (Page 20)

18
20. Attach mounting angles (items #4 & #5)
using six capscrews (item #32) with lock
washers and capscrews (items #35 &
#31) . Torque capscrews to 34 ft. lb. (46
Nm.) each. Insert plug (item #54) into bot-
tom of gear housing. Permatex may be
applied to threads to help prevent leak-
age.
Pour 3/4 pint of EP 140 gear oil into
housing through hole in top of housing.
Insert relief fi tting (item #50) into reducer
(item #53) . Reducer should then be
placed into hole on top of gear housing.
Tighten fi tting and reducer securely.
19. Place snap ring (item #65) over end of worm
shaft (item #23) and set into snap ring groove.
Insert key (item #19) into keyway of worm shaft.
Place thrust washer (item #68) over each end of
spur gear shaft (item #21). Set spur gear shaft
assembly into bearing of spur gear housing.
Slide gear (item #12) and(item #68) thrust
washer over end of worm shaft (item #23).
Insert pins (item #57) into cover (item #9 ).
Place gasket (item #44) onto cover. Attach cover
and gasket to spur gear housing using twelve
capscrews (item #28). Torque capscrews to 8 ft.
lb. (10.8 Nm.) each. Insert plug (item #54) into
bottom of spur gear housing. Permatex may be
applied to threads to help prevent oil leakage.
Remove reducer and fi tting (items #50 & #53)
from top of spur gear housing. Pour 1/ 2 pint of
SAE 20 weight motor oil into spur gear box.
Replace reducer and fi tting into top of spur gear
housing. Tighten reducer and fi tting securely.