Ramsey Winch DC-200 SERIES RAM-LOK - Manual (Page 17)

15
12. Check pinion gear on motor for signs of wear. If
necessary replace motor (item # 51).
11. Check cover bushing (item #8) for signs of wear. Re-
place if necessary by removing old bushing and press-
ing new bushing into place.
13. Check gears of spur gear shaft assembly for
signs of wear, replace if necessary. Press old
gears from shaft (item #21). Tap key (item #20)
into keyway of shaft (item #21). Press shaft
through gears so that gears are centered on
shaft and key.
14. Apply grease to end of shaft, opposite gear. Apply
grease to bushing in gear housing (Item#18). Place
greased end of shaft through spacer (item #71) and
bushing in gear housing (item #18). Place gasket (item
#51) onto gear housing cover (item #8). Apply grease to
gear end of shaft and bushing in cover.
Place cover onto shaft and secure to housing with fi ve
(item #29) capscrews at fi ve lower holes.
RE-ASSEMBLY