Ramsey Winch DC-200 SERIES RAM-LOK User Manual

Page 15

4. Slide clutch housing (item #17) from end of drum

shaft. Slide jaw clutch (item #7) from end of drum

shaft.

Remove (2) keys (item # 47) from keyways . A

screw driver can be used, at notch, to aid in remov-

al of keys. Once keys have been removed, drum

(item#10) and thrust washer (item #70) can be

removed from drum shaft. Parts under drum, thrust

washer (item #69), spring and disc (items #66 &

#42) should also be removed.

5. Remove bearing cap (item #6) from gear

housing by unscrewing four capscrews (item

# 29 ). Remove worm (item #23 ) and bearing

(item #25) from gear housing. Use a soft ham-

mer to gently tap input end of worm and drive

worm and bearing from gear housing. Once

worm has been removed from housing, bear-

ing can be pressed from end of worm.

Check for signs of wear to worm (item #23)

and bearings (item #25). Replace if neces-

sary.

For models with optional worm brake refer to
page 5, SERVICING OF THE OIL COOLED

SAFETY BRAKE, for disassembly and page 6,

for re-assembly instructions.

6. Remove gear housing cover (item #8) from

gear housing (item #18) by unscrewing fi ve

remaining capscrews (items #29). Place

capscrew into two tapped holes of cover and

tighten. This will pull the cover loose from gear

housing.

Remove cover gasket (item #45) and pull shaft

(item #22), with gear attached, and spacer

(item #70) from gear housing.