Ramsey Winch RCH 12K HOIST - Manual (Page 8)

7
CABLE INSTALLATION
1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of wire
rope, opposite hook, with plastic or similar tape to prevent fraying.
2. Slide the wire rope through narrow end of the pocket against the drum flange. Wrap the wire
rope around on the anchor (item #16) and pull the wire rope and anchor back into the wide end
of the pocket. Use a soft hammer to drive the back side of the wire rope, firmly seating the wire
rope and anchor into the pockets
3. Carefully run the hoist in the “reel-in” direction. Keeping tension on end of cable, spool all the
cable onto the cable drum, taking care to form neatly wrapped layers.
16