Ramsey Winch RCH 12K HOIST - Manual (Page 12)

11
6. Remove brake cover #5 by removing (8) bolts #19. The cover is spring loaded, use care
when removing. Remove o-ring #25 then springs #38 may be removed; residual oil may be
present in the brake housing.
7. Remove piston #4 including o-rings and backup rings #26, #27, #28, and #29 by using a
momentary puff of compressed air into the brake port located on top of the end bearing.
Capture the piston by placing a shop rag over the opening prior to using air.
8. Remove the sprag brake hub assembly #3, (8) stator plates #6, and (7) disc brakes #7. The
sprag brake hub assembly #3 is not a serviceable part, if damaged a replacement assembly
should be ordered.