Ramsey Winch RCH 12K HOIST - Manual (Page 20)

19
DISASSEMBLY OF OUTPUT CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see below). If purchasing individual parts, it will be necessary to
disassemble the gear carrier as outlined below.
1. Carefully drive roll pin #76 into carrier pin #72 so that it is captured within carrier pin #75 but
not touching the opposite side of the output carrier #72.
2. Tap carrier pin #75 to remove it from the output carrier #72.
3. Slide the gear #73 from the carrier #72
4. Press bearings #77, from the gear #73
5. Remove the roll pin #76 from the carrier pin #75.
6. Repeat this process for the two remaining gears in the carrier.
7. Remove spacer #78 from the carrier #72
ITEM # QTY PART # DESCRIPTION
72 1 317014 OUTPUT CARRIER
73 3 334210 PLANET GEAR
74 6 518069 THRUST WASHER
75 3 470118 CARRIER PIN
76 3 470120 ROLL PIN 3/8 DIA X 7/8 LG
77 9 402138 BEARING-NEEDLE ROLLER
78 1 408386 SPACER
74
77
73
75
72
76
78
74
77
77