Ramsey Winch RCH 12K HOIST - Manual (Page 17)

16
ASSEMBLY OF INPUT CARRIER 19.35 RATIO
Note: Item Numbers refer to Carrier parts list on page 15
1. Place carrier #60 on flat clean surface.
2. Place the gear #61 on a flat thin clean metal plate; Align the bearing with the chamfer facing
toward the gear. Using a press, press the bearing flush to the gear surface.
3. Place thrust washer #64 on top of gear #61. Insert carrier pin #63 into carrier #60, aligning roll
pin #65 with the matching hole on the carrier #60.
4. Insert a thrust washer between gear #61 and carrier #60. Completely insert carrier pin #63 into
carrier #60 using care to align the roll pin hole in carrier pin #63 with the roll pin hole in the
carrier #60.
5. Drive roll pin #65 into carrier #60 until roll pin #65 is ¼” past flush with surface of the carrier
#60.
6. Repeat this process to install the two remaining gears into the carrier.