Ramsey Winch RCH 12K HOIST User Manual

Page 21

Text mode
Original mode

ASSEMBLY OF OUTPUT CARRIER

Note: Item Numbers refer to Carrier parts list on page 19

1. Place output carrier #56 on flat clean surface.
2. Install spacer #62 into the carrier

3. Press in (3) Bearings #61 into gear #57. Repeat this process to install the bearings in the two

remaining gears.

4. Slide the gear #57 into position in the output carrier #56.

5. Insert a thrust washer between gear #57 and output carrier #56. Completely insert carrier pin

#59 into carrier #56 using care to align the roll pin hole in carrier pin #59 with the roll pin hole in
the output carrier #56.

6. Drive roll pin #60 into output carrier #56 until roll pin #60 is flush with surface of the output

carrier #56.

7. Repeat this process to install the two remaining gears into the output carrier.