Ramsey Winch RCH 12K HOIST - Manual (Page 19)

18
ASSEMBLY OF INPUT CARRIER 41.62 RATIO
Note: Item Numbers refer to Carrier parts list on page 17
1. Place carrier #66 on flat clean surface.
2. Place the gear #67 on a flat thin clean metal plate; Align the bearing with the chamfer facing
toward the gear. Using a press, press the bearing flush to the gear surface.
3. Place thrust washer #70 on top of gear #67. Insert carrier pin #69 into carrier #66, aligning roll
pin #71 with the matching hole on the carrier #66.
4. Insert a thrust washer between gear #67 and carrier #66. Completely insert carrier pin #69 into
carrier #66 using care to align the roll pin hole in carrier pin #69 with the roll pin hole in the
carrier #66.
5. Drive roll pin #71 into carrier #66 until roll pin #71 is ¼” past flush with surface of the carrier
#66.
6. Repeat this process to install the two remaining gears into the carrier.