Lincoln Electric IM10038 POWER WAVE C300CE - Manual (Page 29)

B-9 OPERATION B-9
SMAW (STICK) WELDING
SMAW is most often used for outdoor construction,
pipe welding and general repairs. The POWER
WAVE® C300 CE controls Amperage, Output Control
and Arc Force during SMAW welding.
During SMAW welding the wire drive remains idle.
POWER WAVE® C300 CE
EFFECT / RANGE
ARC FORCE
(Soft)-10.0 to
(Crisp)+10.0
DESCRIPTION
Arc
values will provide less short
circuit and softer arc. Higher
settings will provide a higher
short circuit, a more forceful arc
and possibly more spatter.
Force adjusts the short cir-
cuit current for a soft arc, or for
a forceful, driving arc. Lower
No arc ending options are active for
SMAW (Stick) Welding.
END OPTIONS
PROCESS
Stick Soft(7018)
Stick Crisp(6010)
Stick Pipe
MODE
1
2
3
CC STICK MODES
Stick
Soft
7018
1
200 OFF
START OPTIONS
EFFECT / RANGE
START TIME:
0 TO 10 Seconds
DESCRIPTION
If no remote control is installed,
this control sets the time for the
weld output to ramp up or down
from a preset Start current to
the preset Weld current. Use
the WFS/AMP knob to adjust
Start current while the Start
Options LED is lit.
LESS
AMPS MORE
AMPS OUTPUT
OFF OUTPUT
ON
+ +
A
V
M 4T
UltimArc™ Control
BASIC OPERATION
CONTROL OPTIONS