6 panel mounting (afl-w15a-n270) – IEI Integration AFL-W19A_17D_W15A-N270 v3.00 User Manual

Page 46

AFL-W19A/17D/W15A-N270 Panel PC

Page 35

Step 4:

Insert the panel mounting clamps into the pre-formed holes along the edges of

the chassis, behind the aluminum frame.

Step 5:

Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel (Figure 2-26).

Figure 2-26: Tighten the Panel Mounting Clamp Screws

2.6.6 Panel Mounting (AFL-W15A-N270)

To mount the AFL-W19A/17D/W15A-N270 flat panel PC into a panel, please follow the

steps below.

Step 1:

Select the position on the panel to mount the flat panel PC.

Step 2:

Cut out a section from the panel that corresponds to the rear panel dimensions

of the flat panel PC. Take care that the panel section that is cut out is smaller

than the overall size of the metal frame that surrounds the flat panel PC but just