IEI Integration AFL-W19A_17D_W15A-N270 v3.00 - Manual (Page 29)

AFL-W19A/17D/W15A-N270 Panel PC
Page 18
2.5.1 Access the Jumpers
To access the jumpers, please remove the back panel and the internal aluminum chassis.
2.5.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers in described here. Doing so
may disable or damage the system.
The following jumpers are preconfigured for the AFL-W19A/17D/W15A-N270. Users
should no change these jumpers (Table 2-3).
Jumper Name Label Type
LVDS voltage selection J_VLVDS1 4-pin header
Touch Screen Select J1 4-pin header
Panel Type and Resolution J_LCD_TYPE1 8-pin header
Table 2-3: Preconfigured Jumpers
2.5.3 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See Table 2-4
Jumper Location:
See Figure 2-8
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in Table 2-4.
CF Setup Description
Open Slave