IEI Integration KINO-QM770 - Manual (Page 70)

KINO-QM770 Mini-ITX SBC
Page 54
WARNING:
The installation instructions described in this manual should be
carefully followed in order to prevent damage to the KINO-QM770,
KINO-QM770 components and injury to the user.
Before and during the installation please DO the following:
ƒ Read the user manual:
o The user manual provides a complete description of the installation
instructions and configuration options.
ƒ Wear an electrostatic discharge cuff (ESD):
o Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
ƒ Place on an antistatic pad:
o When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
ƒ Turn all power off:
o Make sure the product is disconnected from all power supplies and that
no electricity is being fed into the system.
Before and during the installation of the KINO-QM770 DO NOT:
ƒ DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
ƒ DO NOT use the product before verifying all the cables and power connectors
are properly connected.
ƒ DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.