IEI Integration PCIE-Q670 v1.03 - Manual (Page 71)

PCIE-Q670 PICMG 1.3 CPU Card
Page 56
Figure 4-11: DVI-D/USB Kit Installation
Step 3: Mount the DVI-D/USB kit onto the chassis. Once the DVI-D/USB kit is
connected to the board, secure the DVI-D/USB kit bracket to the system
chassis.
4.5.3 SATA Drive Connection
The PCIE-Q670 Series is shipped with four SATA drive cables. To connect the SATA
drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-12.