WEATHER GUARD 114-X-01 THRU 156-X-01 User Manual

Page 2

Note:
• If your pickup is fitted with a plastic drop-in bed liner, it may

need to be drilled, trimmed, or cut for proper installation of
truck box.

• Truck box cover may not properly latch until box is fully bolt-

ed to truck bed (4) places.

• Because truck bed configurations vary, (6) mounting slots

have been provided, to ensure the use of (4) mounting
clamps.

• Periodically check tightness of mounting clamps to insure

proper attachment.

• Use touch-up paint on any drill holes to prevent oxidation.
• Install boxes with vehicle parked on level ground.

Step 1: LOCATE BOX IN TRUCK BED

• Place rubber mounting pads on bed rails.
• Place box into position on top of mounting pads.
• Use ruler to ensure box is centered in truck bed, and

that cover opens fully without interference.

Step 2: ATTACH BOX TO TRUCK BED

• Attach mounting clamp, bolts and washers as shown in

Figure 2.

• Start with slot at drivers side front and work clock-wise until

all four clamps have been installed.

Note: Mounting clamp bolt may be difficult to turn due to the

“lock nut” feature. Apply a small amount of grease to
bolt threads prior to installation to ease assembly.

INSTALLATION INSTRUCTIONS

Rubber
Mounting
Pad

Bed Lip

Mounting Pad

End Panel Slot

Mounting Clamp

Fender Washer

5/16"-18 x 2-1/4"
Hex Head Bolt

Figure 2

Figure 1

Check clearance

with cover open

LOCK SYSTEM
The WEATHER GUARD® Extreme Protection™ Lock is designed to provide maximum security, while providing ease
of use and years of reliable service. When in the locked mode, the button remains retracted in a tamper-resistant
position. When the button is pressed in the unlock mode, the latches are activated and the cover opens.

FEATURE OPERATION

LOCK

Turn the key counterclockwise to the

locked position as indicated on the
lock bezel. When the button is now
pressed, it will stay in the retracted
or tamper-resistant position until
unlocked.

UNLOCKED

Turn the key clockwise to the un-

locked position as indicated on the
lock bezel. Button will pop out and is
now ready to release the latches
when pressed.