Notice – WEATHER GUARD 1285 User Manual

Page 3

WEATHER GUARD® products are protected by one or more of the following trademarks:

U.S. - 842268, 1661625, 1663369, 2228051; Canada - 1218968, 282725; U.K. - 1400720; N.Z. - 296049; AUS. -761964 other trademarks pending.

- NOTICE -

Any modification or unintended use of this product shall immediately void all manufacturers warranties.

Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or

unintended use of this product.

WEATHER GUARD® REFINISHING PROCEDURES

All WEATHER GUARD® products are finished with a polyester powder coating, and it is important to follow
these proce-dures to get proper adhesion. As Knaack

LLC

cannot control the finishing of the products, Knaack

LLC

’s warranty on paint is not applicable on refinished products.

1. Sand the surface to be painted with 180-200 grit sand paper to rough up the surface. This should be followed by wet
sanding with a 400 grit wet or dry paper.

2. Wipe down the sanded surface with ketone based thinner. This removes the dust and softens the powder coating for
better paint adhesion.

3. Wipe sanded area with a tack rag to remove loose dust and particles before painting.

NOTE: Do not use a lacquer over the powdered coating.

Part No. 24-0085 REV. C ECN 5305 04/13

Knaack LLC

ATTN: Warranty Claims

420 TE. erra ACotta venue Crystal ILLake, 60014

If you have any questions, please call toll free at 1-800-456-7865.

This manual is related to the following products:

Model 1285 FAST RACK® Accessory Cab Screen