Warner Electric Gen 2 Clutch_Electrically Released Brake UniModule UM-50FBC, UM-100FBC, UM-180FBC User Manual

Page 2

The 2030FBC UniModule is designed to mount
using a base mounting kit. This allows the
modules to be mounted as a separate drive unit
driven from the prime mover by V-belts, chain
and sprockets, couplings, timing belts and other
standard power transmission components.

(For UniModule sizes 210 and 215 please refer
to Warner Electric manual P-273-2)

For These UM FBC Combinations

Use These

Installation Steps:

Install your specific FBC UniModule
combination according to the installation steps
specified in the table. Use only those steps
indicated for each combination.

UniModule Clutch/Brake between
C-Face Motor and Reducer

1020FBC

UniModule Clutch/Brake

2030FBC

Motor Mount Module Clutch/Brake
on a C-Face Motor

1020FBC-M

Base Mounted
UniModule Clutch/Brake

2030FBC-B

Warner Electric • 800-825-9050

P-273-9 • 819-0530

Contents

Mounting to a C-Face Motor . . . . . . . .3
Mounting to a Reducer . . . . . . . . . . . . .4
Installing the Base Mount . . . . . . . . . . .4
Installing the Motor Mount Bracket . . .4
Mounting to other Power

Transmission Components . . . . . . . .5

Electrical Connections . . . . . . . . . . . . . .6
FB Brake Release Adjustment . . . . . . .6
Troubleshooting-Electrical . . . . . . . . . . .7
Troubleshooting-Mechanical . . . . . . . . .7
Enclosed UniModule Option . . . . . . . . .9

Failure to follow these

instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.

The equipment covered by

this installation manual must be installed in
accordance with these instructions. Failure
to do so may damage the equipment and
void the warranty.

Warner Electric UniModules are designed to
National Electrical Manufacturers Association
(NEMA) standards. They can be mounted to
common NEMA C-Face motors and reducers as
well as common power transmission drive
components.

The 1020FBC UniModule is designed to mount
to the face of a C-Face motor as noted in
Table 1.

Corresponding

NEMA Frame Sizes

C-Face

Old

New

Shaft

Pilot

Size

NEMA

Dia.

56 C

48 Y

5/8"

4-1/2"

100

56 C

48 Y

5/8”

4-1/2”

180

182 C

143 TC

7/8"

4-1/2"

184 C

145 TC

Table 1

Mounting to a Motor
Mounting to a Reducer
Electrical Connections
Brake Release Adjustment

Mounting to other
Power Transmission
Components
Electrical Connections
Brake Release Adjustment

Mounting to a Motor
Installing the Motor
Mount Bracket
Mounting to other
Power Transmission
Components
Electrical Connections
Brake Release Adjustment

Installing the Base Mount
Mounting to other
Power Transmission
Components
Electrical Connections
Brake Release Adjustment