Vanguard CT-7000 S3 - Manual (Page 30)

CT-7000 S3 USER’S MANUAL REV 1
25
3.2.3. Configuring Automatic or Manual Printing of Test Results
The CT-7000 S3 can be configured to print graphs and tabulated results automatically or
manually after each test. To configure the printing method:
a. Start from the “START-UP” menu:
Press the
[4]
key (SETUP).
b. The following screen will be displayed:
Press the [5] key (NEXT PAGE).
c. The following screen will be displayed:
Press the [2] key (SET PRINT MODE).
d. The following screen will be displayed:
Press the [1] key (AUTOMATIC PRINT) to automatically print test results after each test.
Press the
[2]
key (BY REQUEST ONLY) to manually print test results after each test.
Please see section 3.3.5 for instructions on how to manually print test results.
SET PRINT MODE:
1. AUTOMATIC PRINT
2. BY REQUEST ONLY
1. SET DATE & TIME
2. SET PRINT MODE
3. SET 50/60 HZ
4. SET LANGUAGE
5. BLUETOOTH DEV RESET
6. PREVIOUS PAGE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. TIME BREAKER 09/12/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS