Vanguard CT-7000 S3 User Manual

Page 116

Text mode
Original mode

CT-7000 S3 USER’S MANUAL

REV 1

111

4.2

Performing a Transducer Self-Test

You can check the transducer electronics by connecting the transducer to the CT-7000 S3 and
running a transducer self-test using the instructions below:

a. Start from the “START-UP” menu:

Press the

[5]

key (DIAGNOSTICS).

b. The following screen will be displayed:

Press the

[3]

key (TEST TRANSDUCER).

c. The following screen will be displayed:

NOTE

T1 - T3 refer to digital transducers. R1 - R3 refer to resistor type transducers.

Move the transducer slider to a known distance and observe the display.

TRANSDUCER TEST:
T1= 0.00 in / 000.0°
T2= 0.00 in / 000.0°
T3= 0.00 in / 000.0°
R1= 0.00 IN
R2= 0.00 IN
R3= 0.00 IN

1. SLOW CLOSE TEST
2. CHECK HOOKUP
3. TEST TRANSDUCER
4. PRINT DATA
5. ENCODER FILTER
6. CONTACT FILTER

1. TIME BREAKER 09/19/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS