Tracer TP-9361 PRO-Chek CO2 AM08043 - Manual (Page 8)

Removing/Replacing the Power Stick
The PRO-Chek CO2 uses a preassembled power stick.
Remove the battery compartment door on the back of the PRO-Chek
CO2 by pressing on both release buttons on the grip and pulling the door
straight out. The power stick is connected to the PCB board via a miniature
electrical connector. Disengage the connector and slide the power stick
out of the PRO-Chek CO2.
To install a fresh power stick, slide the new stick into the PRO-Chek CO2
and push the miniature connector on the power stick into the mating half on
the PCB board.
Once the power stick is in place, close the battery compartment by aligning
the two tabs and sliding the door straight in until it latches. Ensure the wire
leads on the power stick are not pinched in the door. Allow 10 hours to fully
charge the new power stick.
Replacement Parts and Accessories
Replacement parts and accessories for your PRO-Chek CO2 are available
through the same dealer from whom you bought the instrument.
12-volt cord with cigarette-lighter plug, 12 ft (3.7 m) 125954
120-volt mains adapter and cord, 6 ft (1.8 m) 125955
230-volt (Euro) mains adapter and cord, 6 ft (1.8 m) 125956
230-volt (UK) mains adapter and cord, 6 ft (1.8 m) 125957
240-volt mains adapter and cord, 6 ft (1.8 m) 126000
100-volt mains adapter and cord, 6 ft (1.8 m) 125958
Power stick 125922
Replacement infrared cell 125960
Filter cartridges, package of 5 125921
Replacement probe cap 125923
8