Tracer TP-1390M M-L AM09003-3 - Manual (Page 2)

INTRODUCTION
The TRITAN™ 365 AC/DC series UV-A LED Inspection lamps are equipped with a cord
ending in a male connector plug and an AC/DC adapter cord appropriate for the country of
destination. The kit includes a 12V 3000mAHr NiMH rechargeable battery in a case with an
adjustable shoulder strap. Each smart battery charger is equipped with the cord appropriate
for the country of shipment (120V, 230V, 240V, or 100V). All components are packed in a
sturdy, padded carrying case.
IMPORTANT SAFETY INSTRUCTIONS
• Read all instructions.
• Do not operate the lamp with a damaged cord or if the lamp has been damaged.
• Never use this equipment in any manner not specified in these instructions because the
protection provided by the equipment may be impaired.
• The TRITAN 365 is not approved for use in hazardous atmospheres. Do not attempt to
use it in areas requiring explosion-proof lighting.
CHARGING
The TP-1395A battery pack must be fully charged before first use.
• Check that the voltage characteristics of the battery charger match the voltage of the
AC outlet.
• Align the male connector of the smart charger (TP-1396A) to the female connector of the
battery pack (TP-1395A) and twist both connectors to make a tight connection.
• Attach the AC cord supplied to the TP-1396A charger and plug the unit into a properly
regulated AC outlet.
• A full charge will take approximately 2 hours. The lamp can operate for approximately
3.5 hours after a full charge.
• The charger indicator light will show a variety of colors while charging and will remain
GREEN when the charge is complete and the lamp is ready for use.
• After the battery is charged, first unplug the charger from the outlet, then unplug it from
the fused receptacle.
WARNING: Use only the charger supplied to recharge the battery. Other chargers may
harm the battery and will void the battery’s warranty.
For AC Operation
• Align the male connector of the lamp to the female connector of the AC adapter
(TP-1393A) and twist both connectors to make a tight connection. Attach the plug to the
corresponding AC power source.
• The lamp has a three-position rocker switch ( O–off; I–white light; II–UV light) located on
the handle. Press the switch into the desired light source position to light and use the
Tritan 365.
For DC Operation
• Align the male connector of the lamp to the female connector of the receptacle on the
fully charged TP-1395A battery pack.
• Use the lamp in the same manner as above.
English
Tracerline ® TRITAN ™ 365 AC/DC Series
UV LED Long-Wave Inspection Lamps
TP-1390M
2
DANGER
Ultraviolet radiation emitted from this product. Avoid exposure. ALWAYS WEAR
PROTECTIVE CLOTHING. EXPOSURE MAY CAUSE PREMATURE AGING OF THE SKIN
AND CANCER. ALWAYS WEAR PROTECTIVE EYEWEAR; FAILURE TO DO SO MAY
RESULT IN SEVERE BURNS OR LONG TERM INJURY TO EYE. Never look directly into
the lamp. Exposure can cause eye and skin allergy and allergic reactions. Medications
or cosmetics may increase your sensitivity to ultraviolet radiation. Consult physician
before operating this product if you are using medications or have a history of skin
problems or believe yourself especially sensitive to sunlight.
FOR PROFESSIONAL EXAMINATION USE ONLY