Tracer TP-1130 M-L A03125-2 - Manual (Page 17)

SPECIFICATIONS:
Complete Kit
TP-1130
Includes:
TracerJet™ spray gun TP-1131
Lamp with cigarette lighter plug TP-1100H
Adapter cord with 12V connection TP-1517
Fluorescent water dye TP-3900
Glasses, fluorescence-enhancing TP-9940
Carrying case TP-1142
TracerJet™ Spray Gun TP-1131
Air pressure 80 psi (550 kPa) min;130 psi
(900 kPa) max
Air consumption 13 cfm (380 l/min) @ 100 psi
(688 kPa)
Air connection 1/4 NPT
UV/Blue™ Inspection Lamp TP-1100H
Power 12VDC/5A
Bulb, 50W TP-1110
Fluorescent Water Dye, 8 oz TP-3900-0008
LIMITED WARRANTY
Tracer Products warrants that this product will be free from defects in manufacture.
Tracer Products' obligation under this warranty is limited to repairing or replacing, at the option of
Tracer Products, any part(s) of the product which, if properly installed, used and maintained, proves
upon factory examination to have been defective in material or workmanship within 12 months from
the date of purchase.
This warranty does not apply to any product or part that (1) is normally consumed in operation or (2)
has a normal life inherently shorter than the warranty stated. For example, bulbs are warranted for 30
days.
This warranty is in place of all other warranties of quality. There are no other warranties either oral,
written, express, implied or statutory. IMPLIED WARRANTIES OF FITNESS FOR PURPOSE AND
MERCHANTABILITY ARE EXCLUDED. This warranty and your remedies thereunder are solely as
stated here. In no event shall Tracer Products be liable for special, indirect, incidental or consequential
damages, nor for any damages arising out of delay in shipment or production.
NOTE: For assistance of any kind, contact the Customer Service Department at Tracer Products at
1-800-641-1133. Outside the United States call 516-333-4840.
Retain this information for your record.
Date of Purchase ________________________________
WARNING
• RISK OF EXPLOSION. This equipment has internal arcing or sparking parts that should
not be exposed to flammable vapors. It should be located in an area providing at least
four air changes per hour, or should be located at least 18 inches above the floor.
• Intermittent, short inspection intervals will reduce heat buildup and extend the bulb life.
• Use for a maximum of 5 minutes and allow a 10-minute cooling period before restarting.
• Do not touch the glass filter lens during use.
• Do not look directly into the UV/blue light.
• Do not secure the momentary ON/OFF switch in the ON position. This will void the lamp’s
warranty.
• Always disconnect the lamp from the power source and allow it to cool to the touch
before storing or disassembling.
4 17
English
1. Remove bottle assembly
2. Attach stepped fitting
3. Attach water supply
4. Air compressor connection
(Not included in kit)
Figure 2
1
3
2
4
French
1. Dépose de la bouteille
2. Fixation de la buse
3. Fixation de l'alimentation d'eau
4. Connexion du compresseur d'air (n'est
pas inclus dans le kit)
Spanish
1. Remueva el conjunto de la botella
2. Instale la boquilla escalonada
3. Conecte a la línea de suminist de agua
4. Conexión del compresor de aire
(no viene incluida en el juego)
German
1. Flaschenteile entnehmen
2. Gestuftes Anschlussstück anbringen
3. Wasserzufuhr anbringen
4. Luftkompressorverbindung (im Set
nicht enthalten)