Teledyne LeCroy TF-DSQ - Manual (Page 28)

Operator's Manual
28 TF-DSQ-OM-E RevC
Operating Environment
Before using your accessory, ensure that its operating environment will be maintained within
these parameters:

Temperature: 5 to 40 °C.

Humidity: ≤ 80% RH (non-condensing).

Altitude: 2000 meters Max.
Safety Precautions
CAUTION
Avoid personal injury or damage to your accessory or any equipment connected to it by
reviewing and complying with the following safety precautions:

Use only as intended. The accessory is intended to be used only with the compatible
LeCroy instruments. Use of the accessory and/or the equipment it is connected to in a
manner other than specified may impair the protection mechanisms.

Connect and disconnect properly. Avoid damage through excessive bending.

Do not use in wet/damp or explosive atmospheres.

For indoor use only. The accessory is intended for indoor use and should be operated in a
clean, dry, environment.

Do not operate with suspected failures. Do not use the product if any part is damaged.
All maintenance should be referred to qualified service personnel.

Keep product surfaces clean and dry.
CERTIFICATIONS
CE Compliant
CE Declaration of Conformity
The accessory meets requirements of EMC Directive 2004/108/EC for Electromagnetic
Compatibility and Low Voltage Directive 2006/95/EC for Product Safety.
EMC Directive

EN 61326-1:2006

EMC requirements for electrical equipment for measurement, control, and laboratory
use.