Teledyne LeCroy WaveAce EasyScope Operators Manual - Manual (Page 24)

WaveAce
24 ES-OM-E-RevA
Menu Control Buttons

Menu Option buttons (1-5) - Press to choose menu options. Press a menu option button adjacent to your
selection.
Menu Function Buttons

CURSORS - Press to turn on the cursors and display the Cursor menu. You can use the Cursor menu to
set the Cursor Mode (Auto, Off, Manual, Track). When Cursors are on (CURSORS button is lit), press the
left/right arrow buttons to "turn" the Adjust knob to position the cursors.

ACQUIRE - Press to display Acquire menu. You can use the Acquire menu to set the acquisition
Sampling Mode (Sampling, Peak Detect, Average).

SAVE/RECALL - Press to display the Save/Recall menu. You can use the Save/Recall menu to save and
recall up to 20 scope setups or waveforms in internal memory (up to 20 waveforms) or on a USB memory
device (limited by memory capacity of USB device). You can also use it to recall the default factory
settings, to save waveform data as a comma-delimited file (.CSV), and to save or print the displayed
waveform image.

MEASURE - Press to display a menu of measurement parameters. The Display Type must be set to YT
mode.

DISPLAY - Press to open the Display menu. You can use the Display menu to set grid and waveform
display styles, and persistence.

UTILITY - Press to open the Utility menu. You can use the Utility menu to configure WaveAce features,
such as sound, language, counter, etc. You can also view system status and update software.
General Control Buttons

DEFAULT SETUP - Press to reset the oscilloscope's settings to the default factory configuration. For a list
of default settings, see your WaveAce Getting Started Manual.